Step 1 Please wash your hands. Fill the clean bottle with the designated volume of either distilled, micro-filtered (through 0.2 micron filter), commercially bottled or previously boiled and cooled down water. Always rinse your nasal passages with NeilMed®Sinus Rinse™packets only. Our packets contain a mixture of USP grade sodium chloride and sodium bicarbonate. These ingredients are of the purest quality available to make the dry powder mixture. Rinsing your nasal passages with only plain water without our mixture will result in a severe burning sensation as the plain water is not physiologic for your nasal lining, even if it is appropriate for drinking. Additionally, for your safety, do not use tap or faucet water for dissolving the mixture unless it has been previously boiled for five minutes or more as boiling sterilizes the water. Other choices are distilled, micro-filtered (through 0.2 micron), commercially bottled or, as mentioned earlier, previously boiled water at lukewarm or body temperature. You can store boiled water in a clean container for seven days or more if refrigerated. Do not use non-chlorinated or non-ultra (0.2 micron) filtered well water unless it is boiled and then cooled to lukewarm or body temperature.
*You may warm the water in a microwave in increments of 5 to 10 seconds to avoid overheating the water, damaging the device or scalding your nasal passage.

Step 2 Cut the Sinus Rinse™mixture packet at the corner and pour its contents into the bottle. Tighten the cap and tube on the bottle securely. Place one finger over the tip of the cap and shake the bottle gently to dissolve the mixture.

Step 3 Standing in front of a sink, bend forward to your comfort level and tilt your head down. Keeping your mouth open, without holding your breath, place the cap snugly against your nasal passage. SQUEEZE BOTTLE GENTLY until the solution starts draining from the OPPOSITE nasal passage. Some may drain from your mouth. For a proper rinse, keep squeezing the bottle GENTLY until at least 1/4 to 1/2 (60 mL to 120 mL or 2 to 4 fl oz) of the bottle is used. Do not swallow the solution.

Step 4 Blow your nose very gently, without pinching nose completely to avoid pressure on eardrums. If tolerable, sniff in gently any residual solution remaining in the nasal passage once or twice, because this may clean out the posterior nasopharyngeal area, which is the area at the back of your nasal passage. At times, some solution will reach the back of your throat, so please spit it out. To help drain any residual solution, blow your nose gently while tilting your head forward and to the opposite side of the nasal passage you just rinsed.

Step 5 Now repeat steps 3 and 4 for your other nasal passage. Most users find that rinsing twice a day is beneficial, similar to brushing your teeth. Many doctors recommend rinsing 3-4 times daily or for special circumstances, even rinsing up to 6 times a day is safe. Please follow your physician’s advice.

Step 6 Clean the bottle and cap. Air dry the Sinus Rinse™bottle, cap, and tube on a clean paper towel, a lint free towel, or use NeilMed®NasaDOCK®or NasaDOCK plus™(sold separately) to store the bottle, cap and tube.

It is very important to keep these devices clean and free from any contamination.Replace the bottle every 3 months.
NeilMed^® SINUS RINSE^™ Squeeze Bottle: - Please perform routine inspections of the bottle and tube for any discolorations and cracks. If there are any visual signs of deterioration or permanent color changes, please clean thoroughly. If the discolorations remain after cleansing, discard the items and purchase new ones. We strongly suggest that you follow all these steps after each use of the product.

Step 1: Rinse the cap, tube and bottle using running water.

Step 2: Add a few drops of dish washing liquid or baby shampoo.

Step 3: Attach the cap and tube to the bottle;hold your finger over the opening in the cap and shake the bottle vigorously.

Step 4: Squeeze the bottle hard to allow the soapy solution to clean the interior of the tube and the cap. Empty out the bottle completely.

Step 5: Rinse the soap from the bottle, cap and tube thoroughly and place the items on a clean paper towel to dry or use the preferred NasaDOCK^® or NasaDOCK Plus.

Sodium chloride, sodium bicarbonateIt does not contain iodine and preservatives

Please read Warning before using. Our recommendation is to replace the bottle every three months.
USE ONLY AS DIRECTED, IF SYMPTOMS PERSIST SEE YOUR DOCTOR/HEALTHCARE PROFESSIONAL. ALWAYS READ THE LABEL.

Advantages

Soothing, No Burning or Stinging Large Volume &Low Pressure^™ System for Saline Nasal Irrigation, Moisturization and Daily Nasal Hygiene

Single piece, custom-designed rounded black cap fits any nasal opening. No push and pull components make for easy cleaning.

Preservative, Drug, Iodine, BPA, Gluten and Latex Free

Premixed Packets of USP Grade Sodium Chloride &Sodium Bicarbonate (Purity level 99% or higher)

Excellent cleansing prior to spraying nasal corticosteroids

pH Balanced &Isotonic, or Hypertonic with two or more packets

Smooth Flow with easy squeeze bottle

Empties nearly 95% in upright position

Suitable for use after sinus surgery and during pregnancy. Consult your physician with concerns.

Portable for travel

Manufacturer:
Neilmed Pharmaceuticals

0

Always read the patient information on the leaflet or packaging. It will give you important information about your medicine.